YASKAWA VIPA SPEED7 - FC 113 - Cosine(X) - Cosine

Parameters
Parameter Declaration Data Type Memory Area Description
EN INPUT BOOL I, Q, M, D, L
n Enable
– TRUE: activates the function
– FALSE: deactivates the function
ENO OUTPUT BOOL I, Q, M, D, L
n Status
– TRUE: function executed with error
In the event of an error, the function sets the RLO to signal state ENO to TRUE (if the
input value is out of range from 0 to 2 x p). In this case, the contents of ACCU 1 remain
unchanged. The assignment of the remaining registers and the auxiliary flags are not
changed.
This function is only used to convert the FB 101 of an existing S5 pro-
gram to a function of an S7 program programmable controller.
15.4.2 FC 113 - Cosine(x) - Cosine
The function FC 113 expects the input value in ACCU 1 as a floating point number.
1. The input value must be within the range between zero
(REAL = +0.0000000e+00) ... 2 x p (REAL = +0.6283185e+01)
2. The function also stores the result in ACCU 1 as a floating point number.
3. The input value DWORD = DW#16#0000 0000 is treated the same way as the
floating point value zero (REAL = +0.0000000e+00 in accordance with DWORD =
DW#16#8000 0000).
ð
If the calculation is carried out correctly, the RLO ENO is FALSE after the func-
tion has been called up.
Parameters
Parameter Declaration Data Type Memory Area Description
EN INPUT BOOL I, Q, M, D, L
n Enable
– TRUE: activates the function
– FALSE: deactivates the function
ENO OUTPUT BOOL I, Q, M, D, L
n Status
– TRUE: function executed with error
In the event of an error, if the input value is out of range from 0 ... 2 x p, the function sets
the RLO to signal state ENO to TRUE. In this case, the contents of ACCU 1 remain
unchanged. The assignment of the remaining registers and the auxiliary flags are not
changed.
Error information
Description
Error information
VIPA SPEED7
Standard
S5 Converting > FC 113 - Cosine(x) - Cosine
HB00 | OPL_SP7 | Operation list | en | 18-30 826