YASKAWA VIPA SPEED7 - Usage in VIPA SPEED7 Studio

13.3.4 Usage in VIPA SPEED7 Studio
13.3.4.1 Hardware configuration
Please use the SPEED7 Studio V1.7 and up for the configuration.
If you are using a channel other than channel 0, you must adapt it in the hardware config-
uration and in your user program.
1. Start the SPEED7 Studio.
2. Create a new project at the start page with ‘New project’ and assign a ‘Project
name’ .
ð
A new project is created and the view ‘Devices and networking’ is shown.
3. Click in the Project tree at ‘Add new device ...’ .
ð
A dialog for device selection opens.
4. Select from the ‘Device templates’ your CPU with Pulse Train functionality like the
System MICRO CPU M13-CCF0000 and click at [OK].
ð
The CPU is inserted in ‘Devices and networking’ and the ‘Device configuration’
is opened.
Add CPU in the project
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage Sigma-5/7 Pulse Train > Usage in VIPA SPEED7 Studio
HB00 | OPL_SP7 | Operation list | en | 18-30 408