13.6.3 Wiring
(1) DC 24V for power section supply I/O area (max. 10A)
(2) DC 24V for electronic power supply CPU and I/O area
1. Turn off power supply of the CPU and the inverter drive.
2. If not already installed, install the EtherCAT option card in your inverter drive.
3. Connect the option card and the inverter drive via the enclosed ground cable.
4. Connect the EtherCAT jack ‘X4’ of the CPU to the ‘IN’ jack of the option card via
an EtherCAT cable.
ð
Your system is now ready for commissioning.
Proceeding
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via EtherCAT > Wiring
HB00 | OPL_SP7 | Operation list | en | 18-30 513
To Next Page
Loading...
