YASKAWA VIPA SPEED7 - Usage in VIPA SPEED7 Studio

13.6.4 Usage in VIPA SPEED7 Studio
13.6.4.1 Hardware configuration
Please use the SPEED7 Studio V1.8 and up for the configuration.
1. Start the SPEED7 Studio.
2. Create a new project at the start page with ‘New project’ and assign a ‘Project
name’ .
ð
A new project is created and the view ‘Devices and networking’ is shown.
3. Click in the Project tree at ‘Add new device ...’ .
ð
A dialog for device selection opens.
4. Select from the ‘Device templates’ a CPU with EtherCAT master functionality such
as the CPU 015-CEFNR00 and click at [OK].
ð
The CPU is inserted in ‘Devices and networking’ and the ‘Device configuration’
is opened.
Add CPU in the project
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via EtherCAT > Usage in VIPA SPEED7 Studio
HB00 | OPL_SP7 | Operation list | en | 18-30 514