Peripheral output address:
n This parameter is only available in CPUs from VIPA or S7-300 CPUs from Siemens.
n With ADDR_OUT the output address of the corresponding CP may be determined.
This is the address, which you have assigned via the hardware configuration for the
CP.
HW identifier:
n This parameter is only available in S7-1500 CPUs of Siemens.
n Enter at HW_ID the HW identifier, with which your module can be addressed accord-
ingly.
Ä
Chap. 4.1 ‘HW identifier - HW_ID’ page 66
Number of the DB SEND:
n Number of the data block, which contains the data to send.
n Zero is not permitted.
Data byte number SEND:
n Number of data byte in the data block, starting from which the transmit data are
stored.
Length SEND:
n Length of the user data to be sent.
n It is: 1 ≤ LEN_SEND ≤ 1024.
Number of the DB RECV:
n Number of the data block, which contains the receive data.
n Zero is not permitted.
Data byte number RECV:
n Number of data byte in the data block, starting from which the received data are
stored.
Size I/O area:
n Enter the size of the I/O area. Depending on the host system the CP occupies for
input and output the following bytes in the I/O areas:
– SLIO CPU: 8byte, 20byte or 60byte selectable
– PROFIBUS: 8byte, 20byte or 60byte selectable
– PROFINET: 20byte or 60byte selectable
– CANopen: 8byte
– EtherCAT: 60byte
– DeviceNET: 60byte
– ModbusTCP: 60byte
DONE_SEND is set at order ready without errors and STATUS_SEND = 0000h.
ERROR_SEND is set at order ready with error. Here STATUS_SEND contains the corre-
sponding error message.
ADDR_OUT
HW_ID
DB_NO_SEND
DBB_NO_SEND
LEN_SEND
DB_NO_RECV
DBB_NO_RECV
IO_SIZE
DONE_SEND
ERROR_SEND
VIPA SPEED7
Serial Communication
CP040 > FB 65 - CP040_COM - Communication SLIO CP 040
HB00 | OPL_SP7 | Operation list | en | 18-30 228
To Next Page
Loading...
