13.2.2.3 Usage in VIPA SPEED7 Studio
13.2.2.3.1 Hardware configuration
Please use for configuration the SPEED7 Studio V1.6.1 and up.
1. Start the SPEED7 Studio.
2. Create a new project at the start page with ‘New project’ .
ð
A new project is created and the view ‘Devices and networking’ is shown.
3. Click in the Project tree at ‘Add new device ...’ .
ð
A dialog for device selection opens.
4. Select from the ‘Device templates’ a CPU with EtherCAT master functions such as
CPU 015-CEFNR00 and click at [OK].
ð
The CPU is inserted in ‘Devices and networking’ and the ‘Device configuration’
is opened.
Add CPU in the project
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage Sigma-5/7 EtherCAT > Usage Sigma-7S EtherCAT
HB00 | OPL_SP7 | Operation list | en | 18-30 326
To Next Page
Loading...
