The following functions are available for editing the ‘Entries’ :
n New
– Here you can create a new entry in a dialog by selecting the corre-
sponding entry from the ‘CoE object dictionary’ and making your set-
tings. The entry is accepted with [OK] and is listed in the list of entries.
n Delete
– This allows you to delete a selected entry.
n Edit
– This allows you to edit the general data of an entry.
n Move Up/Down
– This allows you to move the selected entry up or down in the list.
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage Sigma-5/7 EtherCAT > Usage Sigma-7W EtherCAT
HB00 | OPL_SP7 | Operation list | en | 18-30 370
To Next Page
Loading...
