CPU Connection Comment
MICRO
CPU M13C
n PtP communication requires the optional
EM M09 extension module.
n The extension module provides interface
X1: PtP (RS422/485) with fixed pin assign-
ment.
n For connection to the CPU, use a
PROFIBUS connector from VIPA.
n Activate the terminating resistor on the
PROFIBUS connector.
n After switching on the power supply and a
short start-up time, the CPU is ready for
the PtP communication.
System SLIO
CPU 013C
n The CPU has the interface X3 MPI(PtP)
with a fix pinout.
n For connection to the CPU, use a
PROFIBUS connector from VIPA.
n Activate the terminating resistor on the
PROFIBUS connector.
n After switching on the power supply and a
short start-up time or after an overall reset,
the interface has MPI functionality. You can
activate the PtP functionality via the hard-
ware configuration.
Ä
Chap. 13.5.4 ‘Usage in VIPA SPEED7
Studio’ page 457
Ä
Chap. 13.5.5 ‘Usage in Siemens SIMATIC
Manager’ page 471
Ä
Chap. 13.5.6 ‘Usage in Siemens TIA Portal’
page 486
System SLIO
CPU 014 ... 017
n The CPU has the interface X2 PtP(MPI)
which is per default set to PtP communica-
tion (point to point).
n For connection to the CPU, use a
PROFIBUS connector from VIPA.
n Activate the terminating resistor on the
PROFIBUS connector.
n After switching on the power supply and a
short start-up time, the CPU is ready for
the PtP communication.
Connection of the CPU
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Wiring
HB00 | OPL_SP7 | Operation list | en | 18-30 455
To Next Page
Loading...
