1. Click in the Project tree at ‘Devices and networking’ .
ð
You will get a graphical object view of your CPU.
2. Click at the network ‘PG_OP_Ethernet’ .
3.
Select ‘Context menu è Interface properties’.
ð
A dialog window opens. Here you can enter the IP address data for your
Ethernet PG/OP channel. You get valid IP address parameters from your
system administrator.
4. Confirm with [OK].
ð
The IP address data are stored in your project listed in ‘Devices and
networking’ at ‘Local components’ .
After transferring your project your CPU can be accessed via Ethernet PG/OP
channel with the set IP address data.
1.
Click in the Project tree at ‘PLC..CPU M13... è Device configuration’.
ð
The ‘Device configuration’ opens.
2. In the ‘Catalog’ at ‘Components’ , open the ‘Serial’ collection and drag and drop
the serial module ‘M09-0CB00 - Serial2x’ to the left slot of the CPU. By default, the
interface X1 is set to PtP functionality.
Configuration of Ethernet
PG/OP channel
Enable PtP functionality
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Usage in VIPA SPEED7 Studio
HB00 | OPL_SP7 | Operation list | en | 18-30 458
To Next Page
Loading...
