1. Click in the Project tree at ‘Devices and networking’ .
ð
You will get a graphical object view of your CPU.
2. Click at the network ‘PG_OP_Ethernet’ .
3.
Select ‘Context menu è Interface properties’.
ð
A dialog window opens. Here you can enter the IP address data for your
Ethernet PG/OP channel. You get valid IP address parameters from your
system administrator.
4. Confirm with [OK].
ð
The IP address data are stored in your project listed in ‘Devices and
networking’ at ‘Local components’ .
After transferring your project your CPU can be accessed via Ethernet PG/OP
channel with the set IP address data.
1. Click in the Project tree at ‘PLC... > Device configuration’ .
2. Click in the ‘Device configuration’ at ‘0 CPU 013...’ and select ‘Context menu
è Components properties’.
ð
The properties dialog is opened.
3. Click at ‘Advanced configurations’ and select at ‘Function X3’ the value ‘PTP’ .
Configuration of Ethernet
PG/OP channel
Enable PtP functionality
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Usage in VIPA SPEED7 Studio
HB00 | OPL_SP7 | Operation list | en | 18-30 460
To Next Page
Loading...
