YASKAWA VIPA SPEED7 - Page 649

Parameter Declaration Data type Memory block Description
RET_VAL OUTPUT INT I, Q, M, D, L The return value contains an error code if an
error is detected when the function is being
processed.
IOID OUTPUT BYTE I, Q, M, D, L area identifier
LADDR OUTPUT WORD I, Q, M, D, L Logical base address for the module
area identifier:
n "0": if the module is put locally (including expansion rack).
n DP-master-system-ID of the respective decentralized peripheral system when the slot
is located in one of the decentralized peripheral devices.
Rack No., when the address space identification is 0
Station number of the decentralized Peripheral device when falls the area identification
>0
Slot-Number
Submodule slot
(when submodules cannot be inserted this parameter must be 0)
Offset in user-data address space of the module
The return value contains an error code if an error is detected when the function is being
processed.
Value Description
0000h no error
8094h No subnet with the specified SUBNETID configured.
8095h Illegal value for parameter RACK
8096h Illegal value for parameter SLOT
8097h Illegal value for parameter SUBSLOT
8098h Illegal value for parameter SUBADDR
8099h The slot has not been configured.
809Ah The sub address for the selected slot has not been configured.
Area identifier:
n 54h: peripheral input (PI)
n 55h: peripheral output (PQ)
For hybrid modules the SFC returns the area identification of the lower address. When
the addresses are equal the SFC returns identifier 54h.
SUBNETID
Rack
SLOT
SUBSLOT
SUBADDR
RET_VAL (Return value)
IOID
VIPA SPEED7
Integrated Standard
System Functions > SFC 5 - GADR_LGC - Logical address of a channel
HB00 | OPL_SP7 | Operation list | en | 18-30 649