YASKAWA VIPA SPEED7 - Page 896

16.1.2.5 Parameterization error PAFE
The parameterization error byte PAFE is set (output or bit memory), when the block
detects a "parameterization error", e.g. there is no interface or there is an invalid parame-
terization of QANF / ZANF. PAFE has the following structure:
Byte Bit 7 ... Bit 0
0
n Bit 0: error
– 0: no error
– 1: error, error-No. in Bit 4 ... Bit 7
n Bit 3 ... Bit 1: reserved
n Bit 7 ... Bit 4: error number
– 0: no error
– 1: wrong ORG-Format
– 2: area not found (DB not found)
– 3: area too small
– 4: QVZ-error
– 5: wrong indicator word
– 6: no Source-/Destination parameters at SEND/RECEIVE ALL
– 7: interface not found
– 8: interface not specified
– 9: interface overflow
– A: reserved
– B: invalid order-No.
– C: interface of CP doesn’t quit or is negative
– D: Parameter BLGR not allowed
– E: reserved
– F: reserved
VIPA SPEED7
System Blocks
Fetch/Write Communication > SFC 230 ... 238 - Page frame communication
HB00 | OPL_SP7 | Operation list | en | 18-30 896