INDEX
offset
Name Length Description
30 phys_mode1 1byte State of port 1:
n Bit 0: Duplex mode (only relevant if AUI-Mode = 0):
– 1: phys. Layer works full duplex
– 0: phys. Layer works half duplex
n Bit 1: Baud rate ID (only relevant if AUI-Mode = 0):
– 1: phys. Layer works with 100MBaud
– 0: phys. Layer works with 10MBaud
n Bit 2: Link status:
– 1: phys. Layer has link pulses
– 0: phys. Layer has no link pulses
n Bit 3: Auto mode:
– 1: phys. Layer has to automatically adjust to the LAN medium
– 0: phys. Layer will not automatically adjust to the LAN medium
n Bit 6 ... 4: 0
n Bit 7: Validity:
– 0: phys_mode1 has no valid data
– 1: phys_mode1 has valid data
The numbering of the ports is identical to the numbering in the configura-
tion. If the interface has only one port , whose physical properties are
entered at port 1.
31 phys_mode2 1byte State of port 2 (structure like phys_mode1)
... ... ... ...
45 phys_mode1
6
1byte State of port 16 (structure like phys_mode1)
46 reserved 2byte reserved
If you have not carried out any IP configuration, the variables ip_addr,
subnetmask and defaultrouter each have the value zero.
VIPA SPEED7
SSL System status list
Ethernet details of the module - SSL-ID xy37h
HB00 | OPL_SP7 | Operation list | en | 18-30 965
To Next Page
Loading...
