Routine Maintenance
201
2.
3.
Remove the ribbon (if used) and the media.
4. Using the swab from a Zebra Preventive Maintenance Kit, wipe along the brown strip on the printhead
assembly from end to end. In place of the Preventive Maintenance Kit, you may use a clean swab
dipped in 99.7% isopropyl alcohol. Allow the solvent to evaporate.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Open the printhead assembly by rotating the printhead-open lever upward.
To Next Page
Loading...