Zebra ZT600 Series User Manual

Diagnostics and Troubleshooting
221
PRINT LINE
The printer initiates a test sequence that prints an ink/printhead test image multiple times and at varying
speeds. These test labels can be used when making adjustments to the printer’s mechanical assemblies
or to determine if any printhead elements are not working.
During each phase of the test sequence, the printer prints a number of labels at a particular speed and
then pauses.
• Press PAUSE to print additional labels at the same speed.
• Press CANCEL to move to the next phase of the test sequence.
• Press and hold CANCEL to exit the test sequence.
As an alternate way to initiate the PRINT LINE test sequence, reboot the printer while holding PAUSE.
Release PAUSE when the first control panel light turns off. (Formerly called a PAUSE self test.)
Phase
Number of Labels Printed
Each Time
Print Speed
1 15 labels the printer’s slowest speed
2 15 labels 6 in. (152 mm) per second
3 50 labels the printer’s slowest speed
4 50 labels 6 in. (152 mm) per second
5 50 labels the printer’s maximum speed

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C