Zebra ZT600 Series - Page 72

Printer Setup and Operation
72
Configuring the printer with your LAN information (if necessary)
If your printer connected to your network automatically, you do not need to complete this section. Continue
with Adding a Printer from the Zebra Setup Utilities Screen on page 73.
7. Connect the printer to your computer using a USB, serial, or optional parallel port as instructed in
Connect a Computer to the Printer’s USB Port onpage60 or Connect a Computer to the Printer’s
Serial or Parallel Port on page 63.
8. Configure the following printer settings. You can change the values through the Zebra Setup Utilities
(click Configure Printer Connectivity on the Zebra Setup Utilities screen) or by the ways listed at the
following links. Contact your network administrator for the proper values for your network.
• WIRED IP PROTOCOL on page 135 (change the value from ALL to PERMANENT)
• WIRED GATEWAY on page 134 (match the gateway value of your LAN)
• WIRED SUBNET MASK on page 133 (match the subnet value of your LAN)
• WIRED IP ADDRESS onpage132 (assign a unique IP address to the printer)
9. After the print server settings have been configured, reset the network to apply the changes. See
RESET NETWORK on page 147.