CELL-DYN 3000 System Operator’s Manual 5-1
9140240E — May 1995
Chapter 5
Operating Instructions
Introduction
This chapter discusses the operation of the CELL-DYN® 3000. It is
divided into three sections: Set Up Instructions, Routine Operation and
Using the Data Log. The chapter also includes an overview of the Data
Station computer program. The three major menus in the program that
are used for routine operation — Set Up, Run and the Data Log — are
discussed in this chapter. The remaining parts of the program are
discussed in the following chapters:
Calibration —Chapter 6
Quality Control —Chapter 7
Maintenance —Chapter 9
Troubleshooting —Chapter 10
Data Station Program Overview
The Data Station menus are presented as key labels displayed across the
bottom of the screen. Each menu is accessed by pressing the soft key
located directly below the label. (From left to right, these soft keys
correspond to keys F1–F8 on the standard computer keyboard.)
When the Data Station is powered ON, the MAIN MENU Screen,
depicted in Figure5.1, is displayed. The key labels displayed across the
bottom of this screen are used to access all of the sub-menus that are
available. The MAIN MENU keys are listed below.
MAIN MENU KEYS:
SETUP
RUN
DATA LOG
QC LOGS
CALIBRATION
DIAGNOSTICS
SPECIAL PROTOCOLS
To Next Page
Loading...
