CELL-DYN 3000 System Operator’s Manual 5-5
9140240E — May 1995
Chapter 5 Operating Instructions
Setup Instructions
This section discusses the options available when the [SETUP] key is
pressed. (See Figure 5.2.) These options are used to configure the system
according to the laboratory’s requirements. The function of each key is
discussed and set up procedures are given where applicable.
Figure 5.2: Setup Menu Screen
When the [SETUP] key is pressed, the following soft key labels are
displayed:
DATE/TIME
PATIENT LIMITS
REAGENT LOG
QC SETUP MENU
OPERATION SETUP
UNITS SELECTION
CUSTOMIZE REPORT
MAIN
DATE/
TIME
PATIENT
LIMITS
REAGENT
LOG
QC SETUP
MENU
OPERATION
SETUP
UNITS
SELECTION
CUSTOMIZE
REPORT
MAIN
SETUP MENU
Ready
Dec 08 1992
Operator ID
Sequence #
05:51
0067
734
SETUP
To Next Page
Loading...
