Abbott CELL-DYN 3000 - Calibration Procedural Summary

CELL-DYN 3000 System Operator’s Manual 6-5
9140240E — May 1995
Chapter 6 Calibration
Calibration Procedural Summary
Table 6.2: Calibration Procedural Summary
* Be sure to read the Whole Blood Calibration Guidelines section of this chapter for
complete information on fresh whole blood sample requirements.
Step Choices
1. Read appropriate overview Auto-Cal Calibration
Manual Calibration
Mode to Mode Calibration
2. Complete Pre-Calibration
Procedures
3. Open Mode Calibration
Procedures
Choose ONE:
Auto-Cal Using Commercial Calibrator
Auto-Cal Using Fresh Whole Blood*
Manual Calibration*
4. Closed Mode Calibration
Procedures
Choose ONE:
Auto-Cal Mode to Mode Calibration for
CELL-DYN 3000SL
Auto-Cal Mode to Mode Calibration for
CELL-DYN 3000CS*
Manual Mode to Mode Calibration for
CELL-DYN 3000SL OR CS*
5. Complete Post-Calibration
Procedures
Search
Go Back
Book TOC