5-72 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
Instrument Start Up
The Analyzer and Data Station power switches should be left ON at all
times. The instrument has been designed to automatically maintain itself
when it is idle. If the instrument is idle for five minutes, a cleaning cycle
is automatically initiated. If the instrument is idle for four hours, an
automatic Shutdown cycle is initiated. The instrument is placed in the
STANDBY mode at the end of the automatic Shutdown cycle.
Power to the Printer may be left ON or OFF at the operator’s discretion.
Refer to Chapter 11, Printer, for complete instructions for printer
operation.
Power to the Sample Loader may be left ON or OFF at the operator’s
discretion. Refer to Chapter 12, Sample Loader, for complete
instructions for Sample Loader operation.
A complete procedure for powering the system ON or OFF is given in
Chapter10, Troubleshooting.
To Next Page
Loading...
