10-28 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Troubleshooting Chapter 10
Power OFF Procedure
It is not necessary to power OFF the system under routine operating
conditions. The system should be powered OFF if certain service is
performed, if the system is moved or if the system will be inactive for an
extended period of time (longer than seven days).
When controlled conditions require the power to be turned OFF, use the
following procedure.
1. Perform any required maintenance that is due.
2. Perform an Auto-Clean procedure. (If necessary, refer to the
directions given in Chapter 9, Maintenance.)
3. When the Auto-Clean procedure is complete, press [DAILY
SHUTDOWN]. When the daily shutdown is complete, the status
box displays the STANDBY message.
NOTE: If the instrument will be inactive for more than two
weeks, perform the clean for shipping cycle instead of the daily
shutdown cycle. Refer to the instructions given in Chapter9,
Maintenance, for performing this cycle.
4. Turn the power switches OFF in the following order:
a. Data Station
b. Analyzer
c. Sample Loader, if present
d. Printer
NOTE: In an emergency situation, turn OFF the power switches
in any order as quickly as possible. Follow the Power ON
procedure when the emergency is over.
Initializing the System
The term initializing refers to the initialization process that is necessary
after certain problems have been corrected. Initialization is a two-step
process:
1. Initializing the hardware and software
2. Priming the system with reagents
The system is initialized by pressing the [INITIALIZATION] key on the
second DIAGNOSTICS MENU Screen. The system is automatically
initialized whenever the power is turned OFF and ON.
To Next Page
Loading...
