11-2 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Printer Chapter 11
To print tickets, the printer cable must be connected to the ticket printer
port on the back of the Data Station. (See Figure 2.1 for the location of
this port.) Refer to the Customize Printout section in the Set Up section
of Chapter 5, Operating Instructions, for instructions for customizing the
printout.
Loading Individual Tickets
Instructions are given for loading individual tickets. If fanfold,
continuous-feed tickets are used, they should be loaded as directed in the
printer manual for tractor-feed paper.
1. Be sure that the printer is turned ON and the printer cable is
connected to the ticket printer port on the back of the Data Station.
If the connection is incorrect, turn the Data Station power OFF,
change the position of the cable and turn the power back ON.
2. Set the ribbon cartridge headgap lever to adjust for the thickness of
the tickets. Refer to the following figure for the location of the
headgap lever and the printer manual for detailed instructions.
To Next Page
Loading...
