5-114 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
3.Use the Arrow keys on the keyboard to move the cursor to the
desired parameter in the listing under the matrix.
4.Press [SELECT PARAMETER]. The selected parameter is
highlighted and the cursor moves to the first position in Group 1.
NOTE: The key label changes to [PLACE PARAMETER]
and a [CANCEL SELECTION] key is displayed.
5.If necessary, use the Arrow keys on the keyboard to move the
cursor to the desired location and press [PLACE PARAMETER].
NOTE: When the [PLACE PARAMETER] key is pressed, the
selected parameter is displayed in the position indicated by the
cursor and the cursor is then advanced to the next position in the
group.
6.Repeat steps 3–5 until all selections have been made.
7.If desired, press the Print Screen key on the keyboard to obtain a
printout of the selected groups.
8.Press [RETURN] to return to the DATA LOG Screen.
9.The Data Log is displayed configured with the selected parameters.
Standard Groups
The Data Log display may also be customized with predetermined
groups (Standard Groups) of parameters using the [STANDARD
GROUPS] key. Figure 5.44 shows the WBC Group placed in GROUP 1,
the RBC Group placed in GROUP 2, the PLT Group placed in GROUP 3
and the Diff Group placed in GROUP 4.
Procedure Customize Data Log Display
(Standard Groups)
1.From the main DATA LOG Screen, press [CUSTOMIZE DATA
LOG] to display the CUSTOMIZE DISPLAY FOR DATA LOG
Screen.
2.Press [STANDARD GROUPS] to display the CUSTOMIZE
DISPLAY FOR DATA LOG Screen and key labels for Standard
Groups.
3.Use the Arrow keys on the keyboard to move the cursor to the
desired group (1–4) location.
To Next Page
Loading...
