CELL-DYN 3000 System Operator’s Manual 11-1
9140240E — May 1995
Chapter 11
Printer
Introduction
The CELL-DYN® 3000 has the capability of printing graphics reports
and ticket printouts. The printer can be configured as either a graphics
printer for graphics reports or a ticket printer for blank or preprinted
tickets. The same printer can be used for either configuration, but if both
tickets and graphics reports are required, two printers must be installed.
Graphics or ticket reports can be automatically printed at the completion
of each run cycle or on command by the operator.
Instructions for the installation of either printer are given in the Printer
Installation section of Chapter 2, Installation. Complete directions for
customizing the printout type and format are given in the Set Up
Instructions section of Chapter 5, Operating Instructions.
For a detailed description of the printer components and instructions for
changing the ribbon and loading paper, refer to the manuals that
accompany the printer. In particular, note the important safety
instructions.
Printing Graphics Reports
To print graphics, the printer cable must be connected to the graphics
printer port on the back of the Data Station. (See Figure2.1 for the
location of this port.) Refer to the Customize Printout section in the Set
Up section of Chapter 5, Operating Instructions, for instructions for
customizing the printout.
Printing Tickets
The printer can be used to print result data on blank or pre-printed
tickets. Blank tickets are available in continuous tractor-feed sheets.
(These tickets are loaded like continuous-feed paper.) Preprinted tickets
are loaded individually.
This section gives information about printing tickets and instructions for
loading individual pre-printed tickets in the printer when it is configured
to print tickets.
To Next Page
Loading...
