CELL-DYN 3000 System Operator’s Manual 5-53
9140240E — May 1995
Chapter 5 Operating Instructions
Data Station Run Screen
The Upper Left Corner of the Data Station RUN Screen for patient
samples displays the following data entry fields on lines 1–5:
1.NEXT ID This field is used to enter the ID number for the
next sample to be run. (Up to 12 characters may be
entered.) If the Auto Increment feature is active,
AUTO is highlighted at the end of the field. Refer to
the discussion in the Sample Identification section
of the Sample Analysis section in Chapter5 for
more information about this feature.
2.PATIENT This field is used to enter the patient’s name or
identification. (Up to 16 or characters may be
entered.)
NOTE: If "patient" is not the selected specimen type, then a
different data entry field appears on line 2.
•"Res RBC" replaces "PATIENT" when Resistant RBC is
selected.
•"QC Filename" replaces "PATIENT" when QC Specimen is
selected. The number of runs in the QC file and total file
space are displayed to the right of the type as in the
following example: 31/120.
•"Background" replaces "PATIENT" when Background is
selected.
•"ELEC BKGND" replaces "PATIENT" when Electrical
Background is selected.
3.SEX (M/F): These fields are used to enter the sex andDOB: --
/--/-- birth date of the patient.
4.Dr. This field is used to enter the name of the
patient’s physician. (Up to 22 characters may be
entered.)
XB: If the XB analysis is enabled, the XB file status is
displayed to the right of the <DR> entry field.
5.PARAM:/ These fields display the number (1–4) of the
LIMITS: Parameter and Limit sets that will be applied
to the sample results.
NOTE: The Parameter and Limit sets applied to the sample
may be changed after the sample has been run. Refer to the
description of the Data Log [EDIT SPECIMEN] key given in the
“Using the Data Log” section of this chapter.
To Next Page
Loading...
