5-2 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
Main Menu Screen
The MAIN MENU Screen is divided into four sections. The upper left-
hand corner shows the current version of the instrument software. The
upper right-hand corner shows the current date and time, operator ID and
the sequence number. The information in the upper right corner is
displayed on every screen during operation.
Figure 5.1: Main Menu Screen
NOTE: The cursor is positioned at the <OPERATOR ID> field
when the MAIN MENU Screen is displayed. An operator ID of
up to three alphanumeric characters may be entered. (An
operator ID may also be entered from the main CALIBRATION
Screen.) This operator ID will be displayed on all other screens
and printed on all reports.
The Status Box is displayed in the top center of the screen. This box
appears on every screen to show the following:
•Menu in use
•Analyzer status
•Other applicable information such as report or file identity and
any existing fault conditions
SETUP RUN DATA LOG QC LOGS CALIBRA-
TION
DIAG-
NOSTICS
SPECIAL
PROTOCOLS
CD 3000 MAIN MENU
Ready
Dec 08 1992
Operator ID
Sequence #
15:50
734
0067
Version #
To Next Page
Loading...
