3-26 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Principles of Operation Chapter 3
Operational Messages and Data Flagging
Overview
Operational messages and data flags appear on the Data Station RUN
Screen, on printed reports and can be transmitted to a laboratory
computer system. The CELL-DYN 3000 monitors conditions and data
criteria that may affect the displayed results and these messages and flags
are used to alert the operator. Instructions for interpreting all flags,
numeric, scatterplot and histogram data should be incorporated into the
laboratory’s procedure and used to determine the need for further action
and/or review of results. Messages are divided into the following
categories:
Instrument Messages:
•Fault Conditions
•Status Conditions
Parameter Flagging Messages:
•Dispersional Data Alerts
•Suspect Parameter Flags
•Suspect Population Flags
•Interpretive Messages
Detailed descriptions of the messages in each of the categories are given
in this section.
Instrument Fault and Status Conditions
The instrument fault and status conditions are discussed in detail in the
Troubleshooting Guide. These messages are displayed when the
instrument detects an inappropriate condition during specimen
processing. When necessary, data is suppressed. When any of these
messages is displayed, refer to the Troubleshooting Guide for assistance.
Follow the instructions given and take the appropriate corrective action.
When the problem is corrected, repeat the specimen. If the problem
cannot be corrected, contact the Abbott Customer Support Center for
assistance at
1 (800) CELL DYN.
To Next Page
Loading...
