5-40 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
CUSTOMIZE HEADER
TOGGLE ON/OFF
SETUP
RESTORE HEADER (Displayed after other keys are
pressed.)
BLANK HEADER (Displayed after other keys are
pressed.)
When the [TICKET PRINTER] key is pressed, the following soft
key label is also displayed:
BLANK TICKET or
PRE-PRNTD TICKET (The key label alternates
between these two selections.)
When the [CUSTOMIZE PRINTOUT] key is pressed, the screen that
was used for the last entry is displayed. A brief description of the
function of the soft keys is given in this section. For ease of explanation,
the keys are grouped according to the type of printer selected.
The [CUSTOMIZE DISPLAY] key is used to customize the display as
discussed in the preceding section.
The [STOP PRINTING] key is used to stop printing that is in progress.
When the [STOP PRINTING] key is pressed, the following soft key
labels are displayed:
CONFIRM STOP
CANCEL STOP
These keys confirm or cancel the stop printing command. If [CONFIRM
STOP] is pressed, the print buffer (the memory area where the material
is stored while awaiting printing) is cleared and the bulletin line displays
the message:
PRINTING STOPPED. RESET PAPER TO THE TOP OF THE
PAGE
The [TOGGLE ON/OFF] key enables or disables the option selected by
the position of the cursor. The key label is not displayed when a numeric
entry is required.
CUSTOMIZE
DISPLAY
STOP
PRINTING
TOGGLE
ON/OFF
To Next Page
Loading...
