5-86 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
Work List Screen
The WORK LIST Screen is depicted in Figure 5.34. The numbers on
the screen shown in Figure 5.34 correspond with the following numbered
options:
1.WORK LIST
The status of the Work List (OFF or ON) is displayed in this field.
2.BAR CODE
The status of the Bar Code selection (OFF or ON) is displayed in
this field.
3.#
The sequential number of the Work List entries is displayed in this
field. The Work List holds 800 entries. When the Work List is full,
existing entries must be deleted before additional entries can be
made.
4.4-DIGIT BAR CODE
If this type of bar code was selected from the WORK LIST
SETUP Screen and the Bar Code is ON, the bar code number must
be entered in this field.
5.SPECIMEN ID
A bar code number, sample identification number or name may be
entered in this field. Up to 12 characters may be entered. The
sample is identified on the Data Station RUN Screen, in the Data
Log and on the printed report using the information entered in this
field.
NOTE: An entry must be made in this field to create a Work
List.
6.SPECIMEN NAME
The name entered in this field should be associated with the
identification number entered in the Specimen ID field. Up to 16
characters can be entered in this field.
7.LIMIT
This field is used to enter the number of the Patient Limit Set that
will be used for flagging the sample. If no entry is made, the default
(preselected) Patient Limit Set is used.
To Next Page
Loading...
