5-88 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Operating Instructions Chapter 5
The [BAR CODE ON] key is used to create a Work List for samples that
are identified with bar code labels. The key label changes to [BAR
CODE OFF] when the Bar code feature is enabled. The upper left
corner of the display indicates the status of the Bar Code feature.
When the [INSERT/DELETE] key is pressed, the following soft key
labels are displayed:
INSERT
DELETE
The [INSERT] key is used to insert a line of information into the Work
List. The line is inserted at the cursor position and the remainder of the
Work List is moved down one space.
The [DELETE] key is used to delete a line of information from the Work
List. (When information is deleted, the line remains blank.) When the
[DELETE] key is pressed, the following soft key labels are displayed:
CONFIRM DELETION
CANCEL DELETION
These keys are used to confirm or cancel the Delete command.
The [DELETE ALL] key is used to delete all data from the Work List.
When the [DELETE ALL] key is pressed, the following soft key labels
are displayed:
CONFIRM DELETION
CANCEL DELETION
These keys are used to confirm or cancel the Delete All command.
The [PURGE COMPLETED] key is used to delete all Work List entries
for samples that have been successfully run (marked with an N or A in
the Status field) through the Analyzer. When the [PURGE
COMPLETED] key is pressed, the Bulletin line displays the message:
ALL SPECIMENS MARKED WITH ‘N’ OR ‘A’ WILL BE PURGED
The following soft key labels are displayed:
CONFIRM
CANCEL
BAR CODE
ON
INSERT/
DELETE
INSERT
DELETE
DELETE
ALL
PURGE
COMPLETED
To Next Page
Loading...
