Chapter 4 167
Programming Command Cross References
Functional Sort of SCPI Commands
Input/Output/
Configuration
INPut:IMPedance
SYSTem:CONFigure
SYStem:COMMunicate
Markers CALCulate:<measurement>:MARKer: Not all measurements:
1. have markers available
2. have all the documented
markers, or all the marker
functions.
Measurements:
control
ABORt
INITiate:IMMediate
INITiate:CONTinuous
INItiate:RESTart
Measurements:
select mode
INSTrument:SELect Modes include Basic,
Service, GSM, and CDMA.
Measurements:
mode setup
SENSe:CHANnel:TSCode
SENSe:CORRection:BTS
SENSe:CORRection:BS
SENSe:FREQuency:CENTer
SENSe:POWer[:RF]
SENSe:RADio:CARRier
SENSe:RADio:STANdard
SENSe:SYNC
Modesetupparameters are
used for all the
measurements available
within that mode.
Mode setup parameters
persist if you go to a
different mode and then
return to a previous mode.
Measurements:
select
measurement
CONFigure:<measurement>
FETCh:<measurement>
MEASure:<measurement>
READ:<measurement>
Information about the
typesof dataavailable for a
measurement is in
MEASure description.
Measurements:
measurement
setup
SENSe:AVERage:
SENSe:BANDwidth:
SENSe:FREQuency:
SENSe:SWEep:
SENSe:TRIGger:
TRIGger:
Function SCPI Command Subsystems Remarks
To Next Page
Loading...
