Chapter 5 353
Language Reference
STATus Subsystem
Questionable Calibration Register
Questionable Calibration Condition
:STATus:QUEStionable:CALibration:CONDition?
This query returns the decimal value of the sum of the bits in the
Questionable Calibration Condition register.
NOTE The data in this register is continuously updated and reflects the
current conditions.
Questionable Calibration Enable
:STATus:QUEStionable:CALibration:ENABle <number>
:STATus:QUEStionable:CALibration:ENABle?
This command determines what bits in the Questionable Calibration
Condition Register will set bits in the Questionable Calibration Event
register, which also sets the Calibration Summary bit (bit 8) in the
Questionable Register. The variable <number> is the sum of the
decimal values of the bits you want to enable.
Example STAT:QUES:CAL:ENABLE 16384 could be used if you
have turned off the automatic alignment and you want
to query if an alignment is needed.
Factory Preset
and *RST:
Range: 0 to 32767
Questionable Calibration Event Query
:STATus:QUEStionable:CALibration[:EVENt]?
This query returns the decimal value of the sum of the bits in the
Questionable Calibration Event register.
NOTE The register requires that the associated PTR or NTR filters be set
before a condition register bit can set a bit in the event register.
The data in this register is latched until it is queried. Once queried, the
register is cleared.
To Next Page
Loading...
Need help?
General
