Agilent Technologies E4406A VSA Series - Video (IF) Trigger Slope

Chapter 5 377
Language Reference
TRIGger Subsystem
Video (IF) Trigger Slope
:TRIGger[:SEQuence]:IF:SLOPe NEGative|POSitive
:TRIGger[:SEQuence]:IF:SLOPe?
Sets the trigger slope when using the IF (video) trigger.
Factory Preset
and *RST: Positive
Front Panel
Access:
Mode Setup, Trigger, Video (IF Envlp), Slope
RF Burst Trigger Delay
:TRIGger[:SEQuence]:RFBurst:DELay <time>
:TRIGger[:SEQuence]:RFBurst:DELay?
Set the trigger delay when using the RF burst (wideband) trigger.
Factory Preset
and *RST: 0.0 s
Range: −500.0 ms to 500.0 ms
−100.0 ms to 500.0 ms for cdma2000, W-CDMA (3GPP),
or W-CDMA (Trial & ARIB)
Default Unit: seconds
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Delay