302 Chapter5
Language Reference
SENSe Subsystem
Channel Power—Data Points Auto
[:SENSe]:CHPower:POINts:AUTO OFF|ON|0|1
[:SENSe]:CHPower:POINts:AUTO?
Select auto or manual control of the data points. This is an advanced
control that normally does not need to be changed. Setting this to a
value other than the factory default, may cause invalid measurement
results.
Off - the Data Points is uncoupled from the Integration BW.
On - couples the Data Points to the Integration BW.
Factory Preset
and *RST: On
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.
Channel Power—Sweep Time
[:SENSe]:CHPower:SWEep:TIME <time>
[:SENSe]:CHPower:SWEep:TIME?
Sets the sweep time when using the sweep mode.
Factory Preset
and *RST: 68.27 µs
17.07 µs for W-CDMA (3GPP), W-CDMA (Trial & Arib)
Range: 1 µs to 50 ms
Default Unit: seconds
Remarks: You must be in Basic, cdmaOne, cdma2000, W-CDMA
(3GPP), or W-CDMA (Trial & Arib) mode to use this
command. Use INSTrument:SELect to set the mode.
History: Version A.03.00 and later
To Next Page
Loading...
Need help?
General
