Agilent Technologies E4406A VSA Series - RF Port Power Range Maximum Total Power

Chapter 5 309
Language Reference
SENSe Subsystem
RF Port Power Range Maximum Total Power
[:SENSe]:POWer[:RF]:RANge[:UPPer] <power>
[:SENSe]:POWer[:RF]:RANge[:UPPer]?
Set the maximum expected total power level at the radio unit under
test. This value is ignored if RF port power range is set to auto.
External attenuation required above 30 dBm.
Factory Preset
and *RST: −15.0 dBm
Range: −100.0 to 80.0 dBm for EDGE, GSM
−100.0 to 27.7 dBm for cdmaOne, iDEN
−200.0 to 50.0 dBm for NADC, PDC
−200.0 to 100.0 dBm for cdma2000, W-CDMA (3GPP),
W-CDMA (Trial & Arib)
Default Unit: dBm
Remarks: Global to the current mode. This is coupled to the RF
input attenuation
You must be in the Service, cdmaOne,
EDGE(w/GSM),GSM, NADC, PDC, cdma2000,
W-CDMA (3GPP), or W-CDMA (Trial & Arib) mode to
use this command. Use INSTrument:SELect to set the
mode.
Front Panel
Access:
Input, Max Total Pwr (at UUT)