174 Chapter5
Language Reference
Common IEEE Commands
Query Instrument Options
*OPT?
Returns a string of all the installed instrument options.It is a comma
separated list such as: BAC,BAH. There are a few options that include
more then one mode. An istrument with one of these options will report
the option number once for each mode. You would get a response:
BAC,BAE,BAE,BAH For an instrument that contains cdmaOne (BAC),
NADC (BAE), PDC (BAE), and GSM (BAH).
Recall
*RCL <register>
This command recalls the instrument state from the specified
instrument memory register.
Range: registers are an integer, 0 to 19
Front Panel
Access:
File, Recall State
Reset
*RST
This command presets the instrument to a factory defined condition
that is appropriate for remote programming operation. *RST is
equivalent to performing the two commands :SYSTem:PRESet and
*CLS.
The :SYSTem:PRESet command is equivalent to a front panel
Preset.
The front panel
Preset sets instrument parameters to values for good
local/human interaction. The *RST and front panel
Preset will be
different. For example, the *RST will place the instrument in single
sweep while the front panel
Preset will place the instrument in
continuous sweep.
Front Panel
Access:
Preset
To Next Page
Loading...
Need help?
General
