Chapter 5 255
Language Reference
MEASure Group of Commands
Waveform (Time Domain) Measurement
This measures the power in your input signal with respect to time and
is equivalent to zero-span operation in a traditional spectrum analyzer.
You must select the appropriate mode using INSTrument:SELect, to
use these commands.
The general functionality of CONFigure, FETCh, MEASure, and READ
are described at the beginning of this section. See the
SENSe:WAVeform commands for more measurement related
commands.
:CONFigure:WAVeform
:FETCh:WAVeform[n]?
:READ:WAVeform[n]?
:MEASure:WAVeform[n]?
Front Panel
Access:
Measure, Waveform (Time Domain)
After the measurement is selected, press Restore Meas
Defaults to restore factory defaults.
Measurement Results Available
n Results Returned
0 Returns unprocessed I/Q trace data, as a series of comma-separated trace
points, in volts. The I values are listed first in each pair, using the 0 through
even-indexed values. The Q values are the odd-indexed values.
To Next Page
Loading...
Need help?
General
