Agilent Technologies E4406A VSA Series - Sense]:Acp:offset:list:average:type Log|Maximum|Minimum|Rms|Scalar

To Next Page

To Previous Page

268 Chapter5

Language Reference

SENSe Subsystem

Adjacent Channel Power—Type of Offset Averaging

[:SENSe]:ACP:OFFSet:LIST:AVERage:TYPE

LOG|MAXimum|MINimum|RMS|SCALar

[:SENSe]:ACP:OFFSet:LIST:AVERage:TYPE?

Selects the type of averaging to be used for the measurement at each

offset. You can turn off (not use) speciﬁc offsets with the

SENS:ACP:OFFSet:LIST:STATe command.

Factory Preset

and *RST:

Remarks: You must be in Basic, cdmaOne mode to use this

command. Use INSTrument:SELect to set the mode.

History: Revision A.03.00 or later, in cdmaOne revision A.04.00

Adjacent Channel Power—Deﬁne Resolution Bandwidth List

iDEN mode

[:SENSe]:ACP:OFFSet:BANDwidth|BWIDth <res_bw>

[:SENSe]:ACP:OFFSet:BANDwidth|BWIDth?

Basic mode

[:SENSe]:ACP:OFFSet:LIST:BANDwidth|BWIDth

<res_bw>,<res_bw>,<res_bw>,<res_bw>,<res_bw>

[:SENSe]:ACP:OFFSet:LIST:BANDwidth|BWIDth?

cdma2000, W-CDMA (3GPP) mode

[:SENSe]:ACP:OFFSet[n]:LIST:BANDwidth|BWIDth

<res_bw>,<res_bw>,<res_bw>,<res_bw>,<res_bw>

[:SENSe]:ACP:OFFSet[n]:LIST:BANDwidth|BWIDth?

cdmaOne, W-CDMA (Trial & Arib) mode

[:SENSe]:ACP:OFFSet[n]:LIST[n]:BANDwidth|BWIDth

<res_bw>,<res_bw>,<res_bw>,<res_bw>,<res_bw>

[:SENSe]:ACP:OFFSet[n]:LIST[n]:BANDwidth|BWIDth?

Mode Offset A Offset B Offset C Offset D Offset E

Basic &

cdmaOne

RMS RMS RMS RMS RMS

Other manuals for Agilent Technologies E4406A VSA Series