Agilent Technologies E4406A VSA Series User Manual

312 Chapter5
Language Reference
SENSe Subsystem
Power vs. Time (Burst Power) Measurement
Commands for querying the power versus time measurement results
and for setting to the default values are found in the “MEASure Group
of Commands” on page 233. The equivalent front panel keys for the
parameters described in the following commands, are found under the
Meas Setup key, after the Power vs Time measurement has been selected
from the
MEASURE key menu.
Power vs. Time—Number of Bursts Averaged
[:SENSe]:PVTime:AVERage:COUNt <integer>
[:SENSe]:PVTime:AVERage:COUNt?
Set the number of bursts that will be averaged. After the specified
number of bursts (average counts), the averaging mode (terminal
control) setting determines the averaging action.
Factory Preset
and *RST: 10
Range: 1 to 10,000
Remarks: You must be in the EDGE(w/GSM), GSM or Service
mode to use this command. Use INSTrument:SELect to
set the mode.
Power vs. Time—Averaging State
[:SENSe]:PVTime:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:PVTime:AVERage[:STATe]?
Turn averaging on or off.
Factory Preset
and *RST: Off
Remarks: You must be in the EDGE(w/GSM), GSM or Service
mode to use this command. Use INSTrument:SELect to
set the mode.

Agilent Technologies E4406A VSA Series Specifications

General

Brand	Agilent Technologies
Model	E4406A VSA Series
Category	Test Equipment
Language	English