Chapter 5 297
Language Reference
SENSe Subsystem
Time Slot Auto
[:SENSe]:CHANnel:SLOT:AUTO OFF|ON|0|1
[:SENSe]:CHANnel:SLOT:AUTO?
Select auto or manual control for slot searching. The feature is only
supported in external and frame trigger source modes. In external
trigger mode when timeslot is set on, the demodulation measurement is
made on the nth timeslot specified by the external trigger point + n
timeslots, where n is the selected timeslot value 0 to 7. In frame trigger
mode when timeslot is set on, then demodulation measurement is only
made on the nth timeslot specified by bit 0 of frame reference burst + n
timeslots, where n is the selected timeslot value 0 to 7 and where the
frame reference burst is specified by Ref Burst and Ref TSC (Std)
combination.
Factory Preset
and *RST: On, for NADC, PDC mode
Off, for GSM mode
Remarks: The command is only applicable for mobile station
testing, device = MS.
You must be in EDGE(w/GSM), GSM, NADC, PDC
mode to use this command.Use INSTrument:SELect to
set the mode.
History: Added GSM mode, version A.03.00 or later
Training Sequence Code (TSC)
[:SENSe]:CHANnel:TSCode <integer>
[:SENSe]:CHANnel:TSCode?
Set the training sequence code to search for, with normal burst selected
and TSC auto set to off.
Factory Preset
and *RST: 0
Range: 0 to 7
Remarks: Global to the current mode.
You must be in the EDGE(w/GSM), GSM mode to use
this command. Use INSTrument:SELect to set the
mode.
History: Version A.03.00 or later
Front Panel
Access:
FREQUENCY Channel, TSC (Std)
To Next Page
Loading...
Need help?
General
