Chapter 5 325
Language Reference
SENSe Subsystem
Spectrum (Frequency-Domain) Measurement
Commands for querying the spectrum measurement results and for
setting to the default values are found in the “MEASure Group of
Commands” on page 233. The equivalent front panel keys for the
parameters described in the following commands, are found under the
Meas Setup key, after the Spectrum (Freq Domain) measurement has been
selected from the
MEASURE key menu.
Spectrum—Data Acquisition Packing
[:SENSe]:SPECtrum:ACQuisition:PACKing
AUTO|LONG|MEDium|SHORt
[:SENSe]:SPECtrum:ACQuisition:PACKing?
Select the amount of data acquisition packing. This is an advanced
control that normally does not need to be changed.
Factory Preset
and *RST: Auto
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
Spectrum—ADC Dither
[:SENSe]:SPECtrum:ADC:DITHer[:STATe] AUTO|ON|OFF|2|1|0
[:SENSe]:SPECtrum:ADC:DITHer[:STATe]?
Turn the ADC dither on or off. This is an advanced control that
normally does not need to be changed.
Factory Preset
and *RST: Auto
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
To Next Page
Loading...
Need help?
General
