Chapter 5 263
Language Reference
SENSe Subsystem
Adjacent Channel Power—Averaging Termination Control
[:SENSe]:ACP:AVERage:TCONtrol EXPonential|REPeat
[:SENSe]:ACP:AVERage:TCONtrol?
Select the type of termination control used for averaging. This
determines the averaging action after the specified number of data
acquisitions (average count) is reached.
Exponential – Each successive data acquisition after the average
count is reached, is exponentially weighted and combined with the
existing average.
Repeat – After reaching the average count, the averaging is reset
and a new average is started.
Factory Preset
and *RST: Repeat for basic, cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib)
Exponential for NADC, PDC, iDEN
Remarks: Use INSTrument:SELect to set the mode.
Adjacent Channel Power—Type of Carrier Averaging
[:SENSe]:ACP:AVERage:TYPE MAXimum|RMS
[:SENSe]:ACP:AVERage:TYPE?
Selects the type of averaging to be used for the measurement of the
carrier.
Factory Preset
and *RST: RMS
Remarks: You must be in Basic, cdmaOne mode to use this
command. Use INSTrument:SELect to set the mode.
History: Revision A.03.00 or later, in cdmaOne revision A.04.00
To Next Page
Loading...
Need help?
General
