338 Chapter5
Language Reference
SENSe Subsystem
Burst Sync Delay
[:SENSe]:SYNC:BURSt:DELay <time>
[:SENSe]:SYNC:BURSt:DELay?
Set the delay for the burst measurement position from the reference
position that is determined by sync word or the burst rising/falling
edges.
Factory Preset
and *RST: 0 sec
Range: −500 ms to 500 ms
Default Unit: seconds
Remarks: You must be in the iDEN, NADC or PDC mode to use
this command. Use INSTrument:SELect to set the
mode.
Sync Burst RF Amplitude Delay
[:SENSe]:SYNC:BURSt:RFAMplitude:DELay <time>
[:SENSe]:SYNC:BURSt:RFAMplitude:DELay?
Set the delay for the RF amplitude sync.
Factory Preset
and *RST: 0 s
Range: −100 ms to 100 ms
Default Unit: seconds
Remarks: Global to the current mode.
You must be in the EDGE(w/GSM), GSM mode to use
this command. Use INSTrument:SELect to set the
mode.
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Delay
To Next Page
Loading...
