224 Chapter5
Language Reference
HCOPy Subsystem
Color Hard Copy
:HCOPy:IMAGe:COLor[:STATe] OFF|ON|0|1
:HCOPy:IMAGe:COLor[:STATe]?
Selects between color and monochrome mode for hard copy output. You
must set HCOP:DEV:COLOR YES before using this command.
Factory Preset
and *RST: On. This parameter is persistent, which means that it
retains the setting previously selected, even through a
power cycle.
Remarks: Revision A.04.00 and later
Front Panel
Access: Print Setup, Color with Print To:Printer selected
Print a Hard Copy
:HCOPy[:IMMediate]
The entire screen image is output to the printer at the parallel port.
Front Panel
Access:
Print
Form Feed the Print Item
:HCOPy:ITEM:FFEed[:IMMediate]
Sends the printer a command to form feed. No form feed will occur
unless the printer is only partly done. That is, unless it has only printed
one image of a multi-image printout.
History: Revision A.04.00 and later
Front Panel
Access: Print Setup, Eject Page
To Next Page
Loading...
Need help?
General
