340 Chapter5
Language Reference
SENSe Subsystem
Waveform (Time-Domain) Measurement
Commands for querying the waveform measurement results and for
setting to the default values are found in the “MEASure Group of
Commands” on page 233. The equivalent front panel keys for the
parameters described in the following commands, are found under the
Meas Setup key, after the Waveform (Time Domain) measurement has
been selected from the
MEASURE key menu.
Waveform—Data Acquisition Packing
[:SENSe]:WAVeform:ACQuistion:PACKing AUTO|LONG|MEDium|SHORt
[:SENSe]:WAVeform:ACQuistion:PACKing?
This is an advanced control that normally does not need to be changed.
Factory Preset
and *RST: Auto
Remarks: You must be in the Service mode to use this command.
Use INSTrument:SELect to set the mode.
Waveform—ADC Dither State
[:SENSe]:WAVeform:ADC:DITHer[:STATe] |OFF|ON|0|1
[:SENSe]:WAVeform:ADC:DITHer[:STATe]?
This is an Advanced control that normally does not need to be changed.
Factory Preset
and *RST: Off
Remarks: You must be in the Service mode to use this command.
Use INSTrument:SELect to set the mode.
Waveform—Pre-ADC Bandpass Filter
[:SENSe]:WAVeform:ADC:FILTer:[:STATe] OFF|ON|0|1
[:SENSe]:WAVeform:ADC:FILTer:[:STATe]?
Turn the pre-ADC bandpass filter on or off. This is an Advanced control
that normally does not need to be changed.
Preset: Off
Remarks: To use this command, the appropriate mode should be
selected with INSTrument:SELect.
To Next Page
Loading...
Need help?
General
