Agilent Technologies E4406A VSA Series - Calculate:Measurement:Marker[1]|2|3|4:X:position Integer

196 Chapter5
Language Reference
CALCulate Subsystem
Marker X Position
:CALCulate:<measurement>:MARKer[1]|2|3|4:X:POSition
<integer>
:CALCulate:<measurement>:MARKer[1]|2|3|4:X:POSition?
Position the designated marker on its assigned trace at the specified X
position. A trace is composed of a variable number of measurement
points. This number changes depending on the current measurement
conditions. The current number of points must be identified before
using this command to place the marker at a specific location.
The marker must have already been assigned to a trace. Use
:CALCulate:<measurement>:MARKer[1]|2|3|4:TRACe to assign a
marker to a particular trace.
The query returns the current X position for the designated marker.
The measurement must be completed before querying the marker.
Example: CALC:SPEC:MARK:X:POS 500
Range: 0 to a maximum of (3 to 920,000)
Remarks: The keyword for the current measurement must be
specified in the command. (Some examples include:
SPECtrum, WAVeform)
Front Panel
Access:
Marker, <active marker>, RPG
Marker Readout Y Value
:CALCulate:<measurement>:MARKer[1]|2|3|4:Y?
Readout the current Y value for the designated marker on its assigned
trace. The value is in the Y-axis units for the trace (which is often dBm).
The marker must have already been assigned to a trace. Use
:CALCulate:<measurement>:MARKer[1]|2|3|4:TRACe to assign a
marker to a particular trace.
The measurement must be completed before querying the marker.
Example: CALC:SPEC:MARK1:Y?
Default Unit: Matches the units of the trace on which the marker is
positioned
Remarks: The keyword for the current measurement must be
specified in the command. (Some examples include:
SPECtrum, WAVeform)