Chapter 5 261
Language Reference
READ Subsystem
READ Subsystem
The READ? commands are used with several other commands and are
documented in the section on the “MEASure Group of Commands” on
page 233.
Initiate and Read Measurement Data
:READ:<measurement>[n]?
A READ? query must specify the desired measurement. It will cause a
measurement to occur without changing any of the current settings and
will return any valid results. The code number n selects the kind of
results that will be returned. The available measurements and data
results are described in the “MEASure Group of Commands” on
page 233.
To Next Page
Loading...
