210 Chapter5
Language Reference
CONFigure Subsystem
CONFigure Subsystem
The CONFigure commands are used with several other commands to
control the measurementprocess. These commands are described in the
section on the “MEASure Group of Commands” on page 233.
Configure the Selected Measurement
:CONFigure:<measurement>
A CONFigure command must specify the desired measurement. It will
set the instrument settings for that measurements standard defaults,
but will not initiate the taking of data. The available measurements are
described in the MEASure subsystem.
Configure Query
:CONFigure?
The CONFigure query returns the name of the current measurement.
To Next Page
Loading...
