Agilent Technologies E4406A VSA Series - Correction for Base Station RF Port External Attenuation

304 Chapter5
Language Reference
SENSe Subsystem
Correction for Base Station RF Port External
Attenuation
[:SENSe]:CORRection:BS[:RF]:LOSS <rel_power>
[:SENSe]:CORRection:BS[:RF]:LOSS?
Set the correction equal to the external attenuation used when
measuring base stations.
Factory Preset
and *RST: 0 dB
Range: 0 to 100 dB for cdmaOne
−50 to 50 dB for Basic, iDEN, NADC or PDC
Default Unit: dB
Remarks: You must be in the Basic, iDEN, cdmaOne, NADC or
PDC mode to use this command. Use
INSTrument:SELect to set the mode.
Value is global to the current mode.
Correction for BTS RF Port External Attenuation
[:SENSe]:CORRection:BTS[:RF]:LOSS <rel_power>
[:SENSe]:CORRection:BTS[:RF]:LOSS?
Set equal to the external attenuation used when measuring base
transmit stations.
Factory Preset
and *RST: 0.0 dB
Range: 0.0 to 100.0 dB for GSM
−50.0 to 50.0 dB for cdma2000, W-CDMA (3GPP), or
W-CDMA (Trial & Arib)
Default Unit: dB
Remarks: Global to the current mode.
You must be in the EDGE(w/GSM), GSM,
cdma2000,W-CDMA (3GPP), or W-CDMA(Trial & Arib)
mode to use this command. Use INSTrument:SELect to
set the mode.