Chapter 5 299
Language Reference
SENSe Subsystem
Channel Power Measurement
Commands for querying the channel power measurement results and
for setting to the default values are found in the “MEASure Group of
Commands” on page 233. The equivalent front panel keys for the
parameters described in the following commands, are found under the
Meas Setup key, after the Channel Power measurement has been selected
from the
MEASURE key menu. CHPower used instead of the more
std-compliant CPOWer, as that syntax was already used for Carrier
Power measurement (but has since been renamed).
Channel Power—Average Count
[:SENSe]:CHPower:AVERage:COUNt <integer>
[:SENSe]:CHPower:AVERage:COUNt?
Set the number of data acquisitions that will be averaged. After the
specified number of average counts, the averaging mode (terminal
control) setting determines the averaging action.
Factory Preset
and *RST: 20
Range: 1 to 10,000
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.
Channel Power—Averaging State
[:SENSe]:CHPower:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:CHPower:AVERage[:STATe]?
Turn averaging on or off.
Factory Preset
and *RST: On
Remarks: You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), W-CDMA (Trial & Arib), or Basic mode to use
this command. Use INSTrument:SELect to set the
mode.
To Next Page
Loading...
Need help?
General
